Amazon BFB-3000 Instrukcja Użytkownika Pobierz pdf (Strona 4)

D o c u m e n t N o : D 1 0 0 2 5 2

Page: 4

RapMan V3.1.0 Build Manual

400813 Full filament reel turntable

A new reel turntable reduces the amount of load on the extruders.

1. Remove all spools of material from the BfB 3000.

2. Ensure that the Y dead-stop (see previous retrofit 400771) has been fitted.

3. Rotate the BfB 3000 onto its back and remove the base by unscrewing the four feet. (this is optional but can

make the installation easier)

4. From the base, remove the old filament reel post (Figure 3) by unscrewing the lower M5 bolt from the base.

Discard the old reel post assembly.

Figure 3: Old reel post

5. Prepare the new filament reel turntable: unscrew the M5 nut which is loosely fastened to the end of the

central bolt (Figure 4), taking care to keep the spacers from falling off the central bolt.

Figure 4: New filament reel turntable

6. Position the reel turntable over the base and fit the central bolt down into the base hole (where the old reel

post was fastened), again taking care to keep the spacers from falling off the central bolt.

7. Re-fasten the nut onto the central bolt from the underside of the base to lock the turntable into position, as

illustrated in Figure 5. Ensure that the spacers are correctly positioned (identified in Figure 5).

8. Check the turntable spins freely.

Lower

M5 bolt

M5 nut

Central bolt

1 2 3 4 5 6 7 8 9 ... 12 13

Brak uwag

Amazon BFB-3000 Instrukcja Użytkownika Strona 4